Characterization and correlation of mobile phase dispersion of aqueous-organic solvent systems in centrifugal partition chromatography.

To reach a high separation efficiency using Centrifugal Partition Chromatography (CPC), the fluid dynamical behavior of the liquid-liquid two-phase systems must be clearly understood. The fluid dynamics, namely the dispersion, the coalescence, and the stationary phase retention, have a high impact on a separation. Especially the mobile phase dispersion influences the mass transfer during a separation. In this study, the mobile phase dispersion of different aqueous-organic solvent systems was characterized for ascending and descending mode via video analysis. Thereby the influence of the physical properties of the solvent systems, the operating parameters, and the geometry of the chamber inlet was investigated systematically using dimensional analysis. With the help of the dimensionless numbers Ohnesorge number (OhCPC), Eötvös number (EoCPC), and Weber number (WeCPC) the impact of the solvent system, the plant parameters, and the operating parameters on the mobile phase dispersion could be described. Inside the three dimensional area, spanned by the dimensionless numbers, each state of mobile phase dispersion (undispersed, low dispersed, highly dispersed, and atomized) could be allocated to an individual region for both operating modes. Moreover, differences in mobile phase deflection depending on the operating mode and a possible reason for these were described.

Effectiveness of several solutions to prevent the formation of precipitate due to the interaction between sodium hypochlorite and chlorhexidine and its effect on bond strength of an epoxy-based sealer.

AIM: To evaluate the effectiveness of isopropyl alcohol, saline or distilled water to prevent the precipitate formed between sodium hypochlorite (NaOCl) and chlorhexidine (CHX) and its effect on the bond strength of an epoxy-based sealer in radicular dentine. METHODOLOGY: The root canals of 50 extracted human canines (n = 10) were instrumented. In G1, root canals were irrigated with 17% EDTA and 2.5% NaOCl; G2, as G1, except that 2% CHX was used as the final irrigant. In the other groups, intermediate flushes with isopropyl alcohol (G3), saline (G4) or distilled water (G5) were used between NaOCl and CHX. The specimens were submitted to SEM analysis to evaluate the presence of debris and smear layer, in the apical and cervical segments. In sequence, fifty extracted human canines were distributed into five groups (n = 10), similar to the SEM study. After root filling, the roots were sectioned transversally to obtain dentine slices, in the cervical, middle and apical thirds. The root filling was submitted to a push-out bond strength test using an electromechanical testing machine. Statistical analysis was performed using Kruskal-Wallis and Dunn's tests (α = 5%). RESULTS: All groups had similar amounts of residue precipitated on the canal walls (P > 0.05). The push-out bond strength values were similar for all groups, independently of the root third evaluated (P > 0.05). CONCLUSIONS: Isopropyl alcohol, saline and distilled water failed to prevent the precipitation of residues on canal walls following the use of NaOCl and CHX. The residues did not interfere with the push-out bond strength of the root filling.